Yamaha YXZ1000R Installation Instructions page 3

Fig. 4
Fig. 5
④
10/7/2015
©Yamaha Motor Corporation, U.S.A. All rights reserved.
①+④+⑤
②+③
⑤
Route the Red '+' and Black '-' Cables
6. Install the Red Cable ② to a '+' terminal on the
Contactor and the '+' Auxiliary Terminal or the '+'
on the main battery if the 2
Kit are not installed. See Fig. 1 for the specific
Contactor terminal to connect to.
7. Install the Black Cable ③ to the '–' pole on the
Contactor and the '-' Auxiliary Terminal or the '-'
on the main battery if the 2
Kit are not installed. See Fig. 2, Fig. 3, and Fig.
4. See Fig. 1 for the specific Contactor terminal
to connect to.
Route the Winch Wires
8. Fig. 5 shows the front of the vehicle, near the
winch mount location. The blue and yellow wires
connect to the Winch and route up along the
right hand frame tube. Use cable ties to secure
the two wires to the vehicle.
Page 3 of 4 2HC-F28M1-V0_2 WINCH WIRING KIT
nd
Battery and Wiring
nd
Battery and Wiring