Configuring Cgmp; Disabling Cgmp; Enabling Cgmp Fast−Leave Processing; Disabling Cgmp Fast−Leave Processing - Cisco RJ-45-to-AUX Brochure

Total Number of Entries = 1
To get more detail about the multicast groups, use this command:
Coriolis> (enable) show multicast group [vlan]
CGMP disable
IGMP enable
VLAN Dest MAC/Route Des Destination Ports or VCs / [Protocol Type]
———— —————————————————— ——————————————————————————————————————————
1 01−88−75−88−08−57*
1 11−87−96−54−22−11*
Total Number of Entries = 2
Again, if you only want to see the entries that were learned from IGMP, you can use the command show
multicast group igmp [vlan].

Configuring CGMP

CGMP is disabled by default. Use the following command to enable CGMP:
Coriolis> (enable) set cgmp enable
CGMP support for IP multicast enabled.

Disabling CGMP

To disable CGMP, use the following command:
Coriolis> (enable) set cgmp disable
CGMP support for IP multicast disabled.
Enabling CGMP Fast−Leave Processing
To enable CGMP fast−leave processing, enter the following command:
Coriolis> (enable) set cgmp leave enable
CGMP leave processing enabled.
Disabling CGMP Fast−Leave Processing
To disable CGMP fast−leave processing, enter the following command:
Coriolis> (enable) set cgmp leave disable
CGMP leave processing disabled.

Displaying CGMP Statistics

To display CGMP statistics, use the following command:
Coriolis> (enable) show cgmp stat
CGMP enabled.
CGMP statistics for vlan 1:
valid rx pkts received
invalid rx pkts received
valid cgmp joins received
valid cgmp leaves received
2/1−12
2/1−12
12548
0
12865
147
154