Viewing The Configured Virtual Connections; Configuring The Lecs Atm Address On A Lightstream 1010 Switch; Configuring The Advertised Lecs Address; Viewing The Lane Configuration - Cisco RJ-45-to-AUX Brochure

IF−Side: Network
Uni−type: not applicable Uni−version:
CoriolisLS1010#

Viewing the Configured Virtual Connections

To view the configured virtual connections, use the show atm vp command as shown here:
CoriolisLS1010# show atm vp
Interface VPI Type
ATM3/0/2 2 PVP TUNNEL
CoriolisLS1010#
Configuring the LECS ATM Address on a LightStream 1010
Switch
To configure the LAN Emulation Configuration Server (LECS) ATM address on a LightStream 1010 switch,
follow these steps:
1. Use the enable command to enter Privileged EXEC mode.
2. Use the config terminal command to enter Global Configuration mode.
3. Enter Interface Configuration mode for the correct ATM interface.
4. Use the atm command followed by the address of the LECS:
atm lecs−address atm−address
Tip To verify the address configuration, use the show atm ilmi−configuration command.

Configuring the Advertised LECS Address

To configure the LECS address advertised by the switch to the end system, use the atm lecs−address−default
Global Configuration command. The syntax is as follows:
atm lecs−address−default lecsaddress [sequence #]
Related solutions:
Configuring a LEC for an ELAN
Configuring the LECS

Viewing the LANE Configuration

To view the LANE configuration on a LightStream series switch, use the show lane command as follows:
CoriolisLS1010# show lane
LE Server ATM2/0.2 ELAN name: elan1 Admin: up State: operational
type: ethernet
ATM address: 47.0091810000000060707B8A01.1122334455AA.02
LECS used: 47.0091810000000060707B8A01.0060705A8F05.00 connected, vcd 1450
IF−type: NNI
X−Interface X−VPI
Max Frame Size: 1516
not applicable
Status
Found on page:
271
273
191