Horizontal Units - Top Removal - Hussmann Proto-Aire Installation Manual

Protocol™ Installation and
Service Manual
Horizontal Units – Top Removal
To remove the top assembly, first remove the front panels. Then remove the bracket screw
at top center of each panel opening and above the control panel. Slide the top assembly
forward until the back clips disengage. Lift the top off. Reverse procedure to install.
For some under-table applications, it may be desirable to remove the finished top panel to
reduce the Protocol™ unit's height by two inches. To separate the top panel assembly,
remove it and take out the screws holding the finished top panel to the sub-panel. The sub-
panel MUST be installed, even when the finished top is not used.
5