Table of Contents
Advertisement
531474-1_A_777c2_English.qxd
11/3/2005
Side Beam Range
(WideSide® transducer: WideSide® view only)
Side Beam Range sets the deepest range that will be displayed in the WideSide®
View. The range must be set manually to keep the bottom visible on the display. If
the Side Beam Range is set too deep for current depth conditions the sonar
information will become compressed on the display and valuable detail will be lost.
A WideSide® transducer must be connected to the 700 Series™ Fishing System. Side
Beam Range menu choice is available when Transducer Select is set to WideSide®
(see Sonar Menu Tab: Transducer Select) and can only be accessed from the
WideSide® view.
NOTE: The Side Beam Range requires the purchase of the WideSide® transducer. You can
visit our website at www.humminbird.com to order this accessory online or contact our
Customer Resource Center at 1-800-633-1468.
To adjust the Side Beam Range:
1. Make sure you are in WideSide® Transducer Mode and that a WideSide®
transducer is connected, then highlight Side Beam Range on the Sonar
X-Press
TM
menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to increase or decrease the
Side Beam Range setting. (6 - 160 feet [2 - 50 meters] [International Models
Only], Default = 160 feet [50 meters])
8:01 PM
Page 38
31
Chart Speed
Chart Speed determines the speed at which the
sonar information moves across the display, and consequently the amount of detail
shown. A faster speed shows more information and is preferred by most anglers;
however, the sonar information moves across the display quickly. A slower speed
keeps the information on the display longer, but the bottom and fish details become
compressed and may be difficult to interpret. Regardless of the Chart Speed setting,
the RTS® Window will update at the maximum rate possible for the depth
conditions. Adjust Chart Speed to your personal preference.
To adjust the Chart Speed:
1. Highlight Chart Speed on the Sonar X-Press
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to increase or decrease the
Chart Speed setting. (1-9, Ultra, where 1 = Slow, 9 = Fast, Ultra = Fastest,
Default = 5)
Zoom Level
(Sonar Zoom View only)
Zoom Level sets the magnification level for the Sonar Zoom View, and is only
available on the X-Press
TM
Menu when the Sonar Zoom View is active. Use Zoom to
increase the display resolution to separate sonar returns that are very close together.
To adjust the Zoom Level:
1. Highlight Zoom Level on the Sonar X-Press
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Zoom Level
setting for the Sonar Zoom View. (2x, 4x, 6x, 8x, Default = 2x)
NOTE: The Zoom Preview Box tracks the bottom and cannot be moved by the user.
32
TM
Menu.
TM
Menu.
Advertisement
Table of Contents
