Cisco InfiniBand 4x User Manual page 52

Configuring the Server Switch Module
Set the on-board clock by entering the clock set command with the following variables:
Step 2
the time of day in hh:mm:ss format
•
• the day in dd format
• the month in mm format
• the year in yy format
The example that follows sets the date to 1:45 am on June 3rd, 2004:
Cisco BladeCenterH# clock set 01:45:00 03 06 04
To configure primary, secondary, and tertiary NTP servers to synchronize the Server Switch with the
network, follow these steps:
Step 1 Switch to Privileged Exec mode by entering the enable command.
Cisco BladeCenterH> enable
Cisco BladeCenterH#
Switch to Global Configuration mode by entering the configure terminal command.
Step 2
Cisco BladeCenterH# configure terminal
Cisco BladeCenterH(config)#
Assign a primary NTP server by entering the ntp command with this information:
Step 3
server-one keyword
•
IP address of the NTP server
•
Cisco BladeCenterH(config)# ntp server-one 10.2.0.13
(Optional, Recommended) Assign a secondary NTP server by entering the ntp command with this
Step 4
information:
server-two keyword
•
IP address of the NTP server
•
Cisco BladeCenterH(config)# ntp server-two 10.2.0.14
(Optional, Recommended) Assign a tertiary NTP server by entering the ntp command with this
Step 5
information:
server-three keyword
•
IP address of the NTP server
•
Cisco BladeCenterH(config)# ntp server-three 10.2.0.15
Cisco 4x InfiniBand Switch Module for IBM BladeCenter User Guide
2-4
Chapter 2 Installing and Configuring the Server Switch
78-17838-01