Table of Contents
Advertisement
Chapter 2
Installing and Configuring the Server Switch
Open a Telnet session to the Server Switch Module with the IP address that you configured in
Step 9
Log in to your Server Switch Module, and then proceed to
your Server Switch Module. Log in with the default user name of USERID and password of
PASSW0RD, where the 0 in PASSW0RD is a zero.
Switch(Cisco BladeCenter)
Cisco BladeCenter login: USERID
Password: xxxxxxxx
Cisco BladeCenter>
Changing the Default Password
Change the default password immediately to secure your Server Switch. To change the default
administrative password, follow these steps:
Step 1
Switch to Privileged Exec mode by entering the enable command.
Cisco BladeCenterH> enable
Cisco BladeCenterH#Switch to Global Configuration mode by entering the
command.
Cisco BladeCenterH# configure terminal
Cisco BladeCenterH(config)#
Step 2
Change the password of the user ID by entering the username command. Include the following:
•
•
•
Cisco BladeCenterH(config)# username USERID password n0accE$$
Return to User Exec mode by entering the exit command with the all keyword.
Step 3
Cisco BladeCenterH(config)# exit all
Cisco BladeCenterH>
Configuring the System Clock
Configure your system clock immediately so that all system messages include accurate timestamps. You
can either configure the clock setting on the onboard Server Switch clock, or you can synchronize your
Server Switch to a network time protocol (NTP) server.
To configure the clock settings on the onboard clock, follow these steps:
Step 1
Switch to Privileged Exec mode by entering the enable command.
Cisco BladeCenterH> enable
Cisco BladeCenterH#
78-17838-01
User ID for which you need to change the password (in this case, USERID)
password keyword
New password that you want to apply to the user ID
"Changing the Default Password"
Cisco 4x InfiniBand Switch Module for IBM BladeCenter User Guide
Configuring the Server Switch Module
Step
to secure
configure terminal
6.
2-3
Advertisement
Table of Contents
