Installing The Switch; Installing The Switch On A Din Rail - Cisco IE 3000 Series Hardware Installation Manual

Chapter 2 Switch Installation

Installing the Switch

This section describes how to install the switch:
•
•
•
Warning This equipment is supplied as "open type" equipment. It must be mounted within an enclosure that is
suitably designed for those specific environmental conditions that will be present and appropriately
designed to prevent personal injury resulting from accessibility to live parts. The interior of the
enclosure must be accessible only by the use of a tool.
The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards. Statement 1063
To prevent the switch from overheating, ensure these minimum clearances:
Caution
– Top and bottom: 4.13 in. (105 mm)
– Exposed side (not connected to the module): 3.54 in. (90 mm)
– Front: 2.56 in. (65 mm)

Installing the Switch on a DIN Rail

The switch ships with latches on the rear panel for a mounting on a DIN rail. See
Figure 2-18
You can install the switch as a standalone device on the DIN rail or with the expansion modules already
connected. You must connect expansion modules to the switch before installing the switch on the DIN
rail. To connect the modules to the switch, follow the steps described in the
Switch" section on page
OL-13017-01
Installing the Switch on a DIN Rail
Installing the Switch on the Wall
Installing the Switch in a Rack
Cisco IE 3000 Switch Rear Panel
2-5.
"Adding Modules to the
Cisco IE 3000 Switch Hardware Installation Guide
Installing the Switch
Figure 2-18.
2-23