Cleaning; Light Bulbs - Hotpoint HSH25GFB Owner's Manual And Installation Instructions

Care and cleaning of the refrigerator.
Behind the Refrigerator
Be careful when moving the refrigerator away from the wall. All
types of floor coverings can be damaged, particularly cushioned
coverings and those with embossed surfaces.
Preparing for Vacation
For long vacations or absences, remove food and unplug the
refrigerator. Clean the interior with a baking soda solution of
one tablespoon (15 ml) of baking soda to one quart (1 l) of water.
Leave the doors open.
Preparing to Move
Secure all loose items such as grille, shelves and drawers by taping them securely in place to prevent damage.
Be sure the refrigerator stays in an upright position during moving.
Replacing the Light Bulbs
NOTE: Turning the refrigerator to the 0 (off) setting via the controls does not shut off electrical power to the refrigerator.
Unplug the refrigerator.
Remove the shelf just below the light shield.
Cleaning the Outside
The dispenser drip area, (on some models)
beneath the grille, should be wiped dry. Water left
in this area may leave deposits. Remove the
deposits by adding undiluted vinegar to the
well. Soak until the deposits disappear or
become loose enough to rinse away.
The dispenser cradle (on some models). Before
cleaning, lock the dispenser by pressing and
holding the Lock pad for
3 seconds. Clean with warm water and baking
soda solution—about a tablespoon (15 ml) of
baking soda to a quart (1 l)
of water. Rinse thoroughly and wipe dry.
Cleaning the Inside
To help prevent odors, leave an open box of
baking soda in the refrigerator and freezer
compartments.
Unplug the refrigerator before cleaning. If this is
not practical, wring excess moisture out of
sponge or cloth when cleaning around switches,
lights or controls.
Use warm water and baking soda solution—
about a tablespoon (15 ml) of baking soda to a
quart (1 l) of water. This both cleans and
neutralizes odors. Rinse and wipe dry.
After cleaning the door gaskets, apply a thin
layer of petroleum jelly to the door gaskets at
the hinge side. This helps keep the gaskets from
sticking and bending out
of shape.
The door handles and trim. Clean with a
cloth dampened with soapy water. Dry
with a soft cloth.
Keep the outside clean. Wipe with a clean cloth
lightly dampened with kitchen appliance wax or
mild liquid dish detergent. Dry and polish with
a clean, soft cloth.
Do not wipe the refrigerator with a soiled dish
cloth or wet towel. These may leave a residue
that can erode the paint. Do not use scouring
pads, powdered cleaners, bleach or cleaners
containing bleach because these products can
scratch and weaken the paint finish.
Drain opening in freezer compartment.
During yearly cleaning, remove bottom freezer
pan and flush a solution of baking soda—1
teaspoon (5 ml) and 2 cups (500 ml) of hot (not
boiling) water— through the drain line with the
help of a meat baster. This will help eliminate
odor and reduce the likelihood of a clogged
drain line. If drain becomes clogged, use a
meat baster and baking soda solution to force
the clog through the drain line.
Avoid cleaning cold glass shelves with hot water
because the extreme temperature difference may
cause them to break. Handle glass shelves carefully.
Bumping tempered glass can cause it to shatter.
Do not wash any plastic refrigerator parts in the
dishwasher.
Pull the refrigerator straight out and return it to position by
pushing it straight in. Moving the refrigerator in a side direction
may result in damage to the floor covering or refrigerator.
When pushing the refrigerator back, make sure you don't roll over
the power cord or icemaker supply line (on some models).
Slide the icemaker power switch to the OFF position and shut off
the water supply to the refrigerator.
Replace with an appliance bulb of the same
or lower wattage.
Reinstall the shelf and plug the refrigerator
back in.
www.Hotpoint.com
9