Restoring The Factory Settings; Block Diagram - Boss DUAL CUBE LX Owner's Manual

Restoring the Factory Settings

Here's how to restore the settings of the to their factory-set condition (factory reset).
MEMO
You can use the dedicated software (p. 4) or an app on your mobile device (p. 9) to back up the settings stored on this unit.
To save the settings, use the dedicated software or app on your mobile device to perform a backup.
1.
Set the [AMP TYPE] knob to "STEREO IN", and turn on the power while holding down the [MEMORY] button.
The [TAP] button blinks.
2.
Press the [TAP] button.
The RECÓPLAY indicators repeatedly blink in sequence. When the blinking stops, all of this unit's settings return to the factory-set state.
NOTE
Don't turn off the power while the factory reset is in progress.
Note when using an already-paired iOS device
After executing a factory reset, you'll need to do the following.
DUAL CUBE MIDI
For details, refer to the owner's manual of your iOS device.

Block Diagram

INPUT
GUITAR /
STEREO IN L, R
INPUT
Bluetooth ADAPTOR
STEREO
i-CUBE LINK / AUX IN
STEREO
CTIA
i-CUBE LINK OUT (MONO)
10
1
Disconnect "DUAL CUBE MIDI".
2
Turn off.
EFFECTS,
PRE AMP EQ
DELAY / REVERB
DIRECT IN
DIRECT OUT ( DRY OUT )
FROM HEADSET MIC
MIC VOL
FROM i-CUBE LINK OUT
DUAL CUBE MIDI
LOOPER
LOOPBACK
LOOPBACK
i-CUBE LINK OUT
USB OUT
SPEAKER OUT
POWER AMP
MASTER
MUTE
CTIA
HEADSET MIC
i-CUBE LINK OUT
(MONO)
USB
PRIMARY ( Windows )
INPUT 1/2, OUTPUT 1/2 ( Mac )
USB
TO DIRECT IN
SECONDARY ( Windows )
FROM DIRECT OUT
INPUT 3/4, OUTPUT 3/4 ( Mac )
* Dedicated USB driver only
SPEAKER
STEREO
PHONES / REC OUT
STEREO
LINE OUT
STEREO