Fisher & Paykel FabricSmart WA8560P Installation Instructions & User Manual page 41

Solving operating problems
PROBLEM
Washer is
continually going
out of balance.
Too much or too
little water when
filling on auto
water level.
Washer is making
noises.
Small puddle
coming from
under the washer.
TROUBLESHOOTING
POSSIBLE CAUSES
Washer may not be level.
Too much water for the load
The washer needs to
determine the correct water
level for the load.
Some loads do not
suit 'Auto' water level,
eg pillows.
Banging.
Other noises.
The water level is too high
for the amount of clothes
and has caused excessive
splashing.
Large bulky garments
(eg pillows, duvet) can
cause splashing.
WHAT TO DO
Check the washer is level and does
not rock in any direction. Refer to
page 9.
Ensure an appropriate water level is
selected for the load size (or select
'Auto' water level).
Refer to page 31 to change the out
of balance recovery mode.
Refer to the 'Wash options' section
for more information.
Manually select the most
appropriate water level for the load.
Load is out of balance. Press
redistribute the load.
Refer to the 'Caring for your washer'
section.
Select a lower water level. Refer to
page 22 for more information.
Wash on the 'Bulky' cycle. Refer to
page 26.
and
39