Fisher & Paykel FabricSmart WA8560P Installation Instructions & User Manual page 32

Wash temperatures
All wash temperatures can be individually adjusted if you think they are too hot or too cold.
Note: the hot temperature will be the same as the hot water supply temperature.
Enter Option Adjustment mode (refer to page 28).
1
Select the 'Heavy' cycle.
2
Select the wash temperature you want to adjust, eg 'Warm', by touching the
3
'Wash Temp' button. The digital display screen displays the current setting.
Touch the 'More'
4
temperature (the temperature setting options will scroll around). Each increment is
equal to approximately 1°C.
Wash Temp
Adjusting the temperature setting, eg increasing the WARM wash temperature by 2°C
Controlled Cold
If the temperature of your cold water supply is very low and you choose to do a 'Cold'
wash, you will not get an effective wash. The 'Controlled Cold' option solves this
problem by adding a small amount of hot water to raise the temperature of the wash to
approximately 20°C.
Enter Option Adjustment mode (refer to page 28).
1
Select the 'Heavy' cycle.
2
Select 'Cold' wash temperature by touching the 'Wash Temp' button (if not already
3
selected).
The digital display shows the temperature adjustment possible. The default setting is
4
which is the same temperature as the incoming water from the supply for cold water.
To get 'Controlled Cold', touch the 'More'
5
will now adjust the cold temperature to approximately 20°C. Each of the remaining
settings equals an approximate 1°C temperature increase or decrease from this point
(excluding
Touch 'POWER'
6
Wash Temp
Changing the cold wash temperature setting from cold tap to 'Controlled Cold'
Note: if you always use 'Cold' or Controlled Cold' water, we recommend that a 'Warm'
or 'Hot' wash be used regularly, eg every 5th wash should be at least a warm one. Warm
water is needed to help maintain the cleanliness of your washer.
30
CHANGING PRE-SET OPTIONS
or 'Less' button to increase or decrease to the desired
OOB Recovery
EOC Beeps
Factory Reset
).
to save the setting (if you wish to make no other changes).
OOB Recovery
EOC Beeps
Factory Reset
button until is displayed. Your washer
Wash Temp
OOB Recovery
EOC Beeps
Factory Reset
,