Table of Contents
Advertisement
Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
Before carrying out any work on the electrical
z
section of the appliance, it must be disconnected
from the mains electricity supply.
Connection to a good earth wiring system is
z
absolutely essential and mandatory.
Alterations to the domestic wiring system must
z
only be made by a qualified electrician.
Fire Hazard
Failure to follow this advice may result in
overheating, burning, and injury.
Do not use adapters, reducers, or branching
z
devices to connect this appliance to the mains
power supply.
Cut Hazard
Failure to use caution could result in injury.
Take care: some edges are sharp.
z
2
WARNING!
!
WARNING!
!
WARNING!
!
SAFETY AND WARNINGS
READ AND SAVE THIS GUIDE
WARNING!
To avoid hazard, follow these instructions carefully before installing or using this appliance.
Please make this information available to the person installing the appliance—doing so
z
could reduce your installation costs.
This appliance must be installed and connected to the mains power supply only by a
z
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty or liability claims.
If the power supply cable is damaged, it must be replaced by the manufacturer, its service
z
agent or similarly qualified person in order to avoid a hazard.
Isolating switch: make sure this oven is connected to a circuit which incorporates an
z
isolating switch providing full disconnection from the power supply in accordance with the
wiring rules.
The oven must be earthed.
z
Do not use adaptors, reducers or branching devices to connect the oven to the mains
z
electricity supply, as they can cause overheating and burning.
The appliance must not be installed behind a decorative door in order to avoid
z
overheating.
Please take extra care not to damage the lower trim of the oven during installation. The
z
trim is important for correct air circulation and allows the door to open and close without
obstruction. The manufacturer does not accept any responsibility for damage resulting
from incorrect installation.
Advertisement
Table of Contents
