Schumacher SL879U Owner's Manual page 3

4. FEATURES
1. 15W COB LED
2. Included stand
3. Battery pack
4. Power button
5. Battery level LEDs
5. CHARGING
IMPORTANT! CHARGE THE WORK
LIGHT IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE, AND AT
LEAST EVERY 3-6 MONTHS.
Failure to do this will reduce the battery's
capacity and may void the warranty.
5.1 Before charging, make sure the work light
is turned off.
5.2 Remove the connection cover on the back
of the light.
5.3 Using the AC charger: Insert the end of
the AC charger cable into the input jack
on the back of the work light. Attach the
appropriate plug adaptor to the charger.
Plug the AC charger into a live AC outlet.
5.4 Using the DC charger: Insert the end of
the DC charger cable into the input jack
on the back of the work light. Plug the DC
charger into a live DC accessory outlet.
6. OPERATING INSTRUCTIONS
USING THE WORK LIGHT
IMPORTANT: Charge the internal battery
before use. (Make sure the work light is
powered off before charging.)
6.1 Direct the lens away from your eyes
before turning the light on.
6.2 Press the Power Level button on the
back of the unit for low power.
6.3 To increase the level of brightness, hold
down the Power Level button.
1
3
2
6. Charging port
7. 100-240V AC wall charger
with adaptors for plug
types A, C, G and I
8. 12V DC charger
4
5
6
7
Accessories (sold separately):
9. SA881U magnetic stand
10. SA882U tripod stand
5.5 The LEDs will indicate battery status:
• Flashing red LED – 10% charged
• Solid red LED – 25% charged
• Solid red and yellow LEDs –
50% charged
• Solid red, yellow and first blue LEDs –
75% charged
• Solid red, yellow and both blue LEDs –
Fully charged
5.6 Charging will take approximately 4.5-5.5
hours.
5.7 When fully charged, unplug the charger from
the power source, and then from the work
light. The work light is now ready for use.
5.8 The battery is replaceable (SA880U battery
pack sold separately).
5.9 Recharge the work light after use, and at
least every 3-6 months.
6.4 Rotate the work light for more precise
positioning.
6.5 When finished using the light, press the
Powel Level button, to turn the unit off.
6.6 You may use the magnetic stand or tripod
(SA881U or SA882U, sold separately)
instead of the included stand.
6.7 Recharge the work light after use, and at
least every 3-6 months.
• 3 •
10
9
8