Fisher & Paykel ACTIVESMART RF605Q User's Installation Manual page 19

Positioning your refrigerator
Your Fisher & Paykel ActiveSmart™
refrigerator is fitted with front and rear
rollers to allow you to easily move your
refrigerator forward and backward.
Avoid moving your refrigerator sideways to
prevent damaging the rollers or the floor
covering surface.
Your refrigerator will arrive with the front feet wound up making moving the product
A
into its final location a simple task.
Roll the refrigerator into its final position making sure there is the correct air gap
B
between the product and surrounding cabinetry. See minimum clearance in cabinetry
dimensions table.
Adjust the front feet down until the refrigerator is leaning backward with the front
C
approximately 10mm higher than the back. This will ensure a good door closing action.
Levelling of refrigerator doors
Open the door that is out of alignment.
● ●
Lift the door upwards.
● ●
Clip the spacer onto the centre hinge
● ●
pin (refer to A).
Close the door to recheck alignment.
● ●
INSTALLATION INSTRUCTIONS
Lower the front of
the refrigerator
Refrigerator feet
Raise the front of
the refrigerator
A
17