Fisher & Paykel ACTIVESMART RF605Q User's Installation Manual page 18

Connecting water (Water dispensing and Automatic Ice models)
Ensure the refrigerator is NOT plugged into a power supply. Locate the isolation tap for
1
cold water connection. (Tee and tap fitting not supplied).
Locate the water fitting kit to complete water connection installation.
2
Uncoil tubing from the back of the refrigerator and connect the quick fitting (A).
3
Connect one end of the long tubing (3.5m) to the quick fitting, and insert the other end
4
to the PLV (B).
– Ensure the short arrow on the PLV is pointing away from the tap. The arrow
indicates the direction of water flow.
Insert the short tubing into the water tap adaptor, push tubing in at least 16mm before
5
reaching the stop. Pull gently on the short tubing to ensure it is locked in place (C).
– If the short tubing is already attached to the water tape adaptor skip this step.
Insert the other end of the short tubing firmly to the PLV (D).
6
Fasten the water tap adaptor to the isolation tap. Take care not to over-tighten the
7
water tap adaptor (E).
Pull gently on all tubing connections to ensure they are locked in place. Turn isolation
8
tap on and check that all connections are dry and free of drips.
16
INSTALLATION INSTRUCTIONS
Quick fitting
A
Isolation tap
Water tap adaptor
Short tubing
D
PLV
B
Long tubing
C
E