Cisco Catalyst 3560-E Getting Started Manual page 5

Press and hold the Mode button for
Step 5
3 seconds. When all of the LEDs above the
Mode button turn green, release the Mode
button.
If the LEDs above the Mode button blink after you press the button, release it. Blinking
Step 6
LEDs mean that the switch is already configured and cannot go into Express Setup mode.
For more information, see the "Resetting the Switch" section on page 21.
Verify that the switch is in Express Setup mode. Make sure that all LEDs above the Mode
Step 7
button are green. (On some switch models, the RPS LED remains off.)
Connect a Category 5 Ethernet cable to one
Step 8
of these locations:
• Any 10/100/1000 Ethernet port on the
switch front panel (for switches with
front-panel Ethernet ports).
• The Ethernet management port on the
switch rear panel.
Connect the other end of the cable to the
Ethernet port on your PC.
Verify that the LEDs on both Ethernet ports are green.
Step 9
Wait 30 seconds.
Launch a web browser on your PC. Enter the
Step 10
IP address 10.0.0.1 in the web browser, and
press Enter.
Step 11
The switch prompts you for the default switch password. Enter the default password, cisco.
The switch ignores text in the username field.
Note
SY ST
R PS
1 2
1X 3 4
5 6
SYST
RPS 7 8
9 10
MAST R 11 12
ST AT
STAT 13 14
DUPL X 11X 15 16
13X 17 18
SPEED 19 20
21
STACK D U PL X 22
23 24
PoE
MODE 25 26
2X 23X 27 28
25X 29 30
31 32
SP EE D 33 34
35
36
12X 37
14X 38
35X 399 40
37X 41 42
43 44
45 46
47
24X
26X
Po E
M O D E 36X
38X
Cata lyst
3560 -E
SERIES
1 2
1X 3 4
SYST 5 6
RPS 7 8
9 10
MASTR 11 12
STAT 13 14
15 16
DUPLX 11X 13X 17 18
SPEED 19 20
21 22
STACK 23 24
PoE
MODE 25 26
2X 23X 27 28
25X 29 30
31 32
33 34
35 36
12X 37
14X 38 399
35X 37X 40 41
42 43 44
45 46
47 48
24X 26X
47X
49
X2-1
36X 38X
X2-2
51
Cata lyst
3560 -E 48X
SERIES PoE-4 8
48
47X
49
X2-1 50
X2-2
51
48X
PoE- 48
52
50
52
5