Installation Warning Statements - Cisco Catalyst 3550 Getting Started Manual

Installation Warning Statements

This section includes the basic installation warning statements.
Warning To prevent the switch from overheating, do not operate it in an area that exceeds the
maximum recommended ambient temperature of 113°F (45°C). To prevent airflow
restriction, allow at least 3 inches (7.6 cm) of clearance around the ventilation openings.
Statement 17B
Warning This equipment is intended to be grounded. Ensure that the host is connected to earth
ground during normal use. Statement 39
Warning Only trained and qualified personnel should be allowed to install, replace, or service
this equipment. Statement 1030
Warning If a redundant power system (RPS) is not connected to the switch, install an RPS
connector cover on the back of the switch. Statement 265
Warning Class 1 laser product. Statement 1008
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take
special precautions to ensure that the system remains stable. The following guidelines
are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with
the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack.
10
Statement 1006