MULTIQUIP WBH21-EF Operation And Parts Manual page 23

PARKING BRAKE/DIRECTION LEVER
Before the power buggy can be put into operational use,
it is best to perform a test run to make certain that all
components are functioning properly.
1. Place the buggy on flat solid ground.
2. Engage the parking brake lever.
3. Place the engine's throttle control (Figure 13) in the
SLOW (idle) position.
4. Place the power buggy's direction lever (Figure 18) in
the forward direction.
Figure 18. Direction Lever
5. Slowly squeeze the speed control lever slightly
(Figure 17), for a short period of time to test the brake
holding capacity. If the buggy moves forward, adjust
the brakes as outlined in the maintenance section of
this manual.
6. If the buggy does not move forward, release the
speed control, and disengage the parking brake. If
the buggy creeps forward or reverse while the parking
brake is disengaged, the machine will require service
adjustment of the pump control lever as outlined in the
maintenance section of this manual.
WBH21-EF POWER BUGGY • OPERATION AND PARTS MANUAL — REV. #0 (01/28/16) — PAGE 23
TRAVELING
1. With the engine running and parking brake released,
place the direction lever (Figure 18) in the forward
direction.
2. Squeeze the speed control lever (Figure 17) slightly
until the buggy begins to move in a forward direction.
Initially, let the buggy travel at about 3 MPH.
3. When using the buggy for the first time, test the brake.
With the right foot, step up and place it on the brake
pedal (Figure 19). Gradually apply pressure to the
brake pedal until the buggy comes to rest.
Figure 19. Brake Pedal
4. Test the brake at different speeds until you are
comfortable with stopping the buggy. If the brakes
do not seem to stop the buggy adequately, refer to
the maintenance section of this manual for brake
adjustment instructions.
5. When starting and stopping is confirmed to be
functioning properly, the buggy is ready for operation.
OPERATION