Cisco Catalyst 3032 Getting Started Manual page 17

Cisco systems catalyst blade switch getting started guide
Hide thumbs Also See for Catalyst 3032:
Table of Contents

Advertisement

Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
Enter an enable secret password, and press Return.
Step 3
The password can be from 1 to 25 alphanumeric characters, can start with a
number, is case sensitive, allows spaces, but ignores leading spaces. The secret
password is encrypted, and the enable password is in plain text.
Enter an enable password, and press Return.
Step 4
Step 5
Enter a virtual terminal (Telnet) password, and press Return.
The password can be from 1 to 25 alphanumeric characters, is case sensitive,
allows spaces, but ignores leading spaces.
(Optional) Configure Simple Network Management Protocol (SNMP) by
Step 6
responding to the prompts.
1.
2.
Enter the interface name (physical interface or VLAN name) of the interface that
Step 7
connects to the management network, and press Return.
Enter vlan1 for the interface name at this prompt.
To configure the interface, enter Yes after the prompt, and then enter the switch
Step 8
IP address and subnet mask. Press Return.
The IP address and subnet mask shown here are examples:
Configuring interface Vlan1:
Configure IP on this interface? [yes]:
IP address for this interface [10.0.0.1]:
Subnet mask for this interface [255.255.255.0] : 255.255.255.0
Class A network is 10.0.0.1, 21 subnet bits; mask is /21
Enter no when the prompt asks you if you would like to enable the switch as a
Step 9
cluster command switch. This switch will be a standalone switch.
Would you like to enable as a cluster command switch? [yes/no]: no
Note
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
OL-14317-01
To configure SNMP later, press Return (which applies the default of no). If
you accept the default, you can configure SNMP later through the CLI.
Configure SNMP Network Management? [no]:
To configure SNMP now, enter yes.
Configure SNMP Network Management? [no]: yes
Community string [public]: public
Clustering is not supported.
Configuring the Switch
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 3130

Table of Contents