Table of Contents
Advertisement
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
Configuring the Switch
Connecting through the DRAC/MC
Step 1
Step 2
Step 3
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
14
Follow these steps when connecting through the DRAC/MC:
Connect one end of a DB9 null-modem or crossover cable to the RS-232 console
serial port of the DRAC/MC. Connect the other end of the cable to the RS-232
console serial port of the PC.
On the PC terminal emulation program:
Set the data format to 8 data bits, 1 stop bit, and no parity.
a.
b.
Set the terminal emulation speed to 115200 baud.
Set Flow Control to none.
c.
Under Properties, select VT100 for Emulation mode.
d.
Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that the
e.
setting is for Terminal keys (not Windows keys).
When using HyperTerminal with Microsoft Windows 2000, ensure that you have
Windows 2000 Service Pack 2 or later installed. With Windows 2000 Service
Pack 2, the arrow keys function properly in the HyperTerminal VT100 emulation.
Go to
www.microsoft.com
On the console monitor, the DRAC/MC application displays a login screen.
Log in by using these defaults:
username root
password calvin
The DRAC/MC command-line interface (CLI) command prompt DRAC/MC:
appears.
If the server chassis is off, use this command to power it on:
Note
racadm chassisaction -m chassis powerup
The switch inserted into the chassis I/O bay automatically powers on
when the server chassis powers on. For more information on configuring
the server chassis by using the CLI, see the Dell Remote Access
Controller/Modular Chassis User's Guide.
for information on Windows 2000 service packs.
OL-14317-01
Advertisement
Table of Contents
