Contender Baltic Birch Neat-N-Trim C50860 Assembly Instructions

Parts:
(2) Side Piece
Center Shelf Piece
(2) Back Piece
Top Shelf Piece
(2) Skirt
Notice - KEEP BACK GROOVES ALIGNED - Do Not Drill!
Step 1: Attach hooks to Side
Pieces, both sides of the
Center Divider and both
sides of the Long Dividers
by using phillips head screw-
driver to screw small screws
into pre-drilled holes before
assembling unit. Make sure
hooks are pointed upwards
toward the top of the panels
as seen in illustration.
Step 5: Insert edge of Center
Divider into mortise of Side
Piece, Top Shelf, and Center
Shelf. Make sure back
grooves are aligned.Insert hex
screws into each of pre-drilled
holes in Bottom Piece.
Tighten down halfway.
ASSEMBLY INSTRUCTIONS
Top Piece
Step 2: Align Skirt with pre-drilled
holes on Bottom Piece. Insert hex
screws into pre-drilled holes in Bottom
Piece. Tighten down. Repeat for re-
maining Skirt Piece.
Step 4: Insert edge of Center
Shelf into mortise of Side
Piece. Insert hex screws into
each of pre-drilled holes in
Side Piece. Tighten down
halfway. Repeat for Top Shelf
Piece. Note: Top Shelf does
not receive hex screws.
Bottom Piece
Center Divider - 5/8" Thick
Short Divider
Step 6: Insert edge of
Long Divider into mortise
of Side Piece, Top Shelf,
and Center Shelf. Insert
hex screws into each of
pre-drilled holes in Bottom
Piece. Tighten
halfway.
(2) Long Divider - 3/8" Thick
Tools Needed:
(32) Hex Screws Allen Wrench
(8) Double Hooks
(16) Small Screws
Phillips Head Screw Driver
(Not Included)
Step 3: Insert edge of Bottom
Piece into mortise of Side
Piece. Make sure back
grooves are aligned. Insert hex
screws into each of pre-drilled
holes in Side Piece and each
of the Skirt. Tighten down
halfway.
down