Verify Port Connectivity; In Case Of Difficulty - Cisco Catalyst 3560-C Getting Started Manual

Catalyst 3560-C and 2960-C Switch Getting Started Guide
Connecting to PoE Devices
Step 1 When you connect the 10/100 or 10/100/1000
downlink ports to IP phones, wireless access
points, and so on, connect a straight-through,
twisted four-pair, Category 5 cable to a switch
port.
Step 2
Connect the other cable end into an RJ-45 port on the other device.

Verify Port Connectivity

In Case of Difficulty

OL-23802-02
You can connect the switch to IP devices such as IP phones and access points.
Some switch models can power the IP device, depending upon the surplus power
they have. See the switch hardware guide for information.
After you connect the switch port and another device, the port LED turns amber
while the switch establishes a link. This process takes about 30 seconds, and then
the LED turns green. If the LED turns off, the target device might not be turned
on, there might be a cable problem, or there might be a problem with the adapter
installed in the target device. See the
for information about online assistance.
If you experience difficulty, help is available in this section and also on
Cisco.com. This section includes Express Setup troubleshooting, how to reset the
switch, how to access help online, and where to find more information.
5
13:02 10/9/00
Re dial
1
4
GHI
7
PQRS
"In Case of Difficulty" section on page 19
Catalyst 3560-C and 2960-C Switch Getting Started Guide
C at al ys
t 2 9 6 0
-C
S er i es
P D
6
7
8
1
2
2000
_
2000
3000
Your current options
New Cal l CFwdAl l more
messages directory
2 3
ABC DEF
services settings
5 6
JKL MNO
VOLUME
8 9
TUV WXYZ
HEADSET MUTE SPEAKER
0
OPER
19