Cisco Catalyst 3030 Getting Started Manual page 7

Cisco Catalyst Blade Switch 3030 Getting Started Guide
The initial configuration assumes that the switch module was never configured,
Note
that it is in the same state as when it was received, and that it is not configured
with a default username and password.
Follow these steps to install the switch module into the server chassis:
Obtain and make note of this information from your network administrator before
Step 1
you begin the switch module installation:
•
•
•
•
•
•
•
Step 2 Select a chassis I/O module bay in which to install the switch module. Follow the
prerequisites listed in the
page
Remove the end-cap (blank plug) from the selected bay. Store the end-cap (blank
Step 3
plug) for future use.
If you have not already done so, touch the static-protective package that contains
Step 4
the switch module to an unpainted metal part of the server chassis for at least 2
seconds.
Step 5 Remove the switch module from its static-protective package.
Ensure that the release latch on the switch module is in the open position
Step 6
(perpendicular to the module):
78-17052-01
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password (encrypted)
Enable password (not encrypted)
Telnet password
SNMP community strings (optional)
"Dell Modular Server Chassis Architecture" section on
1-5.
C o n so le
Cisco Catalyst Blade Switch 3030 Getting Started Guide
Installing the Switch Module in the Server Chassis
1 6 x
1 5 x
1 2 x
1 4 x
1 1 x
1 3 x
1 6 x
1 5 x
1 4 x
1 3 x
1 2 x
1 1 x
C O N
1-7