Cisco Catalyst 3030 Getting Started Manual page 12

Installing the Switch Module in the Server Chassis
On the console monitor, the DRAC/MC application displays a login screen. Log
Step 3
in by using these defaults:
username root
password calvin
The DRAC/MC command-line interface (CLI) command prompt DRAC/MC:
appears.
If the server chassis is off, use this command to power it on:
Step 4
racadm chassisaction -m chassis powerup
The switch module inserted into the chassis I/O bay automatically powers on
when the server chassis powers on. For more information on configuring the
server chassis by using the CLI see the Dell Remote Access Controller/Modular
Chassis User's Guide.
Power cycle the switch module by using this command:
Step 5
racadm chassisaction -m switch-N powercycle
where N is the chassis I/O module bay number in which the switch module is
inserted.
Redirect the DRAC/MC console to the switch module internal serial console
Step 6
interface. Enter this command at the DRAC/MC command prompt:
connect switch-N
where N is the chassis I/O module bay number in which the switch module is
inserted.
To return to the command prompt, press this key sequence:
Enter ~.
First press Enter, press tilde ~ (remember to press the <Shift> key if the tilde
character is located in the upper register of your keyboard), and then press
period . (dot).
Go to
Step 7
the switch module.
Cisco Catalyst Blade Switch 3030 Getting Started Guide
1-12
"Waiting for POST to Complete" section on page 1-13
Cisco Catalyst Blade Switch 3030 Getting Started Guide
to finish configuring
78-17052-01