Table of Contents
Advertisement
Refer to Pictorial 2-5 for the following steps.
Carefully unsolder or cut the following jumper wires:
(
)
Wire between holes Tl and T2.
( )
Wire between holes Rl and R2.
(
)
Wire between holes S2 and S3.
{
)
Wire between holes P2 and P3.
(
)
Wire between holes Z2 and Z3.
(
)
Cut three 3/4" bare wires. Use these wires in the
next three steps.
(
)
Solder a 3/4" bare wire from hole Pl to hole P2.
(
)
Solder a 3/4" bare wire from hole Zl to hole Z2.
(
)
Solder a 3/4" bare wire from hole Xl to hole X2.
(
)
Cut the following lengths of green wire. Then
remove 1/4" of insulation from the ends of each
wire.
1-1/2"
2-3/4"
(
)
Connect and solder one end of the 1-1/2" green
wire to hole T2. Connect and solder the other
end of the wire to the indicated circuit board
foil. NOTE: Be sure to scrape the solder resist
away from this hole on the foil side of the circuit
board to insure a good solder connection.
( )
Connect and solder one end of the 2-3/4" green
wire to hole S2. Connect and solder the other
end of the wire to the indicated circuit board
foil. NOTE: Be sure to scrape the solder resist
away from this hole on the foil side of the circuit
board to insure a good solder connection.
Advertisement
Table of Contents
