Table of Contents
Advertisement
Heathkit
(
)
Locate the 25-pin plug. Then refer to Detail 1-6B
and push the longer pins of the plug into the
two 26-pin sockets so that about half of the plug
pins are in each socket.
( )
Check the two sockets to make sure the edges of
each socket are parallel to the surfaces of the
circuit board.
Detail 1-6B
(
)
Adjust the sockets as necessary so they are
parallel to the circuit board. Then solder all the
socket lugs to the circuit board (both sides).
(
)
Remove and discard the 25-pin plug.
Advertisement
Table of Contents
