Table of Contents
Advertisement
Refer to Detail 1-7B and cut off the indicated
lugs at one end of the remaining 20-pin socket.
Push the prepared 20-pin socket onto the edge
of the circuit board next to the 6-pin sockets.
Make sure the circuit board is between the two
lugs at each socket connector. Also make sure
each lug lines up with a foil on the circuit board.
NOTE: The socket hole where you cut off the
lugs must be between foil contact 49 and the
nearby corner of the circuit board. Solder only
lugs 31 and 49 to the foil on the component side
of the circuit board.
Detail 1-7B
(
)
Locate the 25-pin plug. Thenreferto Detail 1-7C
and push the longer pins of the plug into the
four sockets as shown.
(
)
Check the four sockets to make sure the edges of
each socket are parallel to the surfaces of the
circuit board.
( )
Adjust the sockets as necessary so they are
parallel to the circuit board. Then solder all the
socket lugs to the circuit board (both sides).
( )
Remove and discard the 25-pin plug.
Detail 1-7C
Advertisement
Table of Contents
