Install The 1 Ru Distribution Shelf Ground; Figure - Cisco 124792 User Manual

Chapter 2 System Installation

Figure 2-10

Determine if the system is equipped with the optional 1 RU Distribution Shelf; if so, continue with the
Step 5
"2.2.3.3 Install the 1 RU Distribution Shelf Ground" section on page
"2.3 Install AC Power Cables" section on page

2.2.3.3 Install the 1 RU Distribution Shelf Ground

Step 1 Locate the #10 studs at the rear of the 1 RU Distribution Shelf.
Using a UL-listed 6 AWG (16mm²) wire with an insulation rating of at least 75° C, connect the 1 RU
Step 2
Distribution Shelf to the appropriate cabinet connection point.
The connection at the shelf end is made using a UL-listed double-hole lug 1/4in and 5/8in.
Step 3
center-to-center (lug part # Panduit LCD6-14A-L or equivalent)
To accommodate future upgrades, leave a service loop (1.5ft [60cm]) at the side of the shelf.
Step 4
May 2006
Installing the System Shelf Ground
2-11. If not continue with the
2-12.
(Figure 2-11).
Cisco AC/DC Power System User Guide, R1.0
2.2.3 Install the Ground Cable
2-11