Advertisement
4
供水角阀
Angle valve
地面排污口
Floor drain
十字标记
Cross mark
拆卸以前的供水角阀, 安装上所配置的供水角阀
※在拆卸之前要先关闭总角阀。
※在更换角阀前, 请先排净管道中的泥沙等杂物,直至清水流出。
Remove the previous water supply angle valve and install
the configured water supply angle valve.
※Close the total angle valve before disassembly.
※Before replacing the angle valve, please drain off the sand and
other debris in the pipeline until the clear water flow out.
油泥
Wax ring
将油泥安装在陶瓷底部排污口上，注意连接紧密。
Install the wax ring on the drain outlet at the bottom of the
ceramic, paying attention to the tight connection.
带接地、防水、
防溅电源插座
With a grounded,
waterproof,
splash-proof
power outlet
。
1.将坐便器侧翻，放置在预先准备的泡沫上。
2.目测，在陶瓷排污口中心点所对应的陶瓷侧面上画一条垂直
陶瓷底平面的线，另一侧面同上，同时在陶瓷前部中间点画一条
垂直地面的线。
1.Gently flip the toilet , Place it on the pre-prepared foam board.
2.Take the sewage outlet of ceramic body as the center point, make
a mark on the side of the toilet bowl, it perpendicular to the bottom
plane of the toilet bowl, the other side same as above. At the same
time make a mark in the middle of the front of the toilet bowl, it
perpendicular to the ground.
Advertisement
