Advertisement
二.使用说明 Use Instructions
遥控器对码
1.两个按键同时按下，进入对码模式；
2.长按左边
按键，自动滚动到下一个地址并保存退出；
3.坐便器的侧边旋钮前旋（座温加档）同时按下旋钮4s，听到蜂
鸣器提示音后放开；
4.马上按遥控器
按键，对码完成。
更换遥控器电池
1.把遥控器从卡座上拿下来，用新电池对准遥控器背面的电池盖
凹槽逆时针旋转，取下电池盖;
2.换好纽扣电池，注意电池正极(有文字面)朝上;
3.盖上电池盖，顺时针旋转到位。
遥控器
Remote control
密封圈
Sealing ring
大冲水Full flush
按
键，启动大冲水功能，大水量冲洗坐便器。
Press
amount of water.
小冲水Half flush
按
键，启动小冲水功能，小水量冲洗坐便器。
Press
small amount of water.
纽扣电池
Button Battery
电池盖
Battery cover
button, start the full flush function and flush the toilet with a large
button, start the half flush function and flush the toilet with a
Remote Control Code
1.Press the two buttons at the same time to enter the matching
mode.
2.Long press the
button on the left to automatically scroll to
the next address, save and exit.
3.Turn the button on the side of the toilet forword(Seat temperature
increases) and press the knob for 4s at the same time, release it
after hearing the buzzer sound.
4.Immediately press
button on the remote control to complete
the matching.
Replace The Remote Control Battery
1.Take the remote control out of the holder, align the new battery
with the groove on the battery cover on the back of the remote
control, and then turn it counterclockwise to remove the battery
cover.
2.Replace the button battery, pay attention to the positive side of
the battery(the side with the text)facing up.
3.Put on the battery cover and turn it clockwise into place.
Advertisement
