Table of Contents
Advertisement
Available languages
Available languages
II. Installation and Startup
Instructions
WARNING
1. This icemaker must be installed in accordance with
applicable national, state, and local regulations.
2. CHOKING HAZARD: Ensure all components,
fasteners, and thumbscrews are securely in place
after installation. Make sure that none have fallen
into the storage bin.
A. Checks Before Installation
• Visually inspect the exterior of the shipping container
and immediately report any damage to the carrier. Upon
opening the container, any concealed damage should
also be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material.
If any are left in the icemaker, it will not work properly.
WARNING! Keep packing material (plastic bags and
expanded polystyrene) away from children.
• Remove the panels to prevent damage when installing
the icemaker. See "II. B. How to Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the
icemaker is exposed to the sun or to heat, remove the
film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines
or other surfaces.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the side panel, and check that
your voltage supplied corresponds with the voltage
specified on the nameplate.
• This icemaker can be installed on a storage bin 48"
wide or wider. For options, contact your local Hoshizaki
distributor.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the 2 screws. Lift up and towards
you.
• Top Panel: Remove the 2 screws, then lift off.
• Side Panel (R): Remove the screw. Slide forward slightly
and lift off.
• Insulation Panel: Remove the thumbscrew. Lift up
slightly and pull towards you.
• Top Insulation: Lift off.
Top Insulation
Insulation Panel
Front Panel
Fig. 1
C. Location
1. This icemaker is not intended for outdoor use. Normal
operating ambient temperature should be within 7°C to
38°C; Normal operating water temperature should be
within 7°C to 32°C.
Operation of the icemaker, for extended periods,
outside of these normal temperature ranges may affect
icemaker performance.
2. This icemaker will not work at sub-freezing
temperatures. To prevent damage to the water supply
line, drain the icemaker if the air temperature is going
to go below 0°C. For details, see "III. C. Preparing the
Icemaker for Long Storage."
For best operating results:
• The icemaker should not be located next to ovens, grills, or
other high heat producing equipment.
• The location should provide a firm and level foundation for
the equipment.
• Allow 15cm clearance at rear, sides, and top for proper air
circulation and ease of maintenance and/or service should
they be required.
6
ENGLISH
Top Panel
Side Panel
CAUTION
(R)
Advertisement
Table of Contents
