Test Run - Toshiba RAV-HM561KRTP-E Installation Manual

12

TEST RUN

A wired remote controller is necessary for this function. This function cannot be operate with a wireless
remote controller.
Before test run
• Before turning on the power supply, carry out
the following procedure.
1) Using 500V-megger, check that resistance
of 1MΩ or more exists between the terminal
block of the power supply and the earth
(grounding).
If resistance of less than 1MΩ is detected,
do not run the unit.
2) Check the valve of the outdoor unit being
opened fully.
• To protect the compressor at activation time,
leave power-ON for 12 hours or more before
operating.
Execute a test run
Operate the unit with the remote controller as
usual.
For the procedure of the operation, refer to the
attached Owner's Manual to the outdoor unit.
A forced test run can be executed in the following
procedure even if the operation stops by
thermostat-OFF.
In order to prevent a serial operation, the forced
test run is released after 60 minutes have passed
and returns to the usual operation.
CAUTION
• Do not use the forced test run for cases
other than the test run because it applies an
excessive load to the devices.
Wired remote controller
Be sure to stop the air conditioner before
making settings.
(Change the setup while the air conditioner is not
working.)
1
Push and hold OFF timer button and
[ ] setting button simultaneously for
10 seconds or more. [TEST] is displayed
on the display part and the test run is
permitted.
2
Push ON/OFF button.
3
Push menu button to select the operation
mode. Select [
[ ] [ ] setting button, and then push
menu button (three times) again to
determine the operation mode.
• Do not run the air conditioner in a mode
other than [Cool] or [Heat].
• The temperature setting function does not
work during test run.
• The check code is displayed as usual.
‒ 40 ‒
Installation Manual
Cool] or [ Heat] with
40-EN