Test Run - Toshiba RAV-GE1301BP Series Installation Manual

11

Test run

Before test run
Before turning on the power supply, carry out the
following procedure.
1) By using 500 V-megger, check that resistance of
1 to 3 and the earth (grounding).
do not run the unit.
2)
opened fully.
Execute a test run
Operate the unit with the wired remote controller as
usual.
For the procedure of the operation, refer to the
attached Owner's Manual.
A
OFF.
In order to prevent a serial operation, the forced test
run is released after 60 minutes have passed and
returns to the usual operation.
CAUTION
Do not use the forced test run for cases other than
the devices.
41-EN
1116950140_01_EN.indd 21 1116950140_01_EN.indd 21
Wired remote controller
2, 4
3
1,5
1
Push button for 4 seconds or more.
[TEST] is displayed on the display part and
the selection of mode in the test mode is
permitted.
2
Push button.
3
Select the operation mode with
button, [ Cool].
Do not run the air conditioner in a mode other
than [ Cool].
The temperature controlling function does not
work during test run.
The detection of error is performed as usual.
4
After the test run, push button to
stop a test run.
1
(Display part is same as procedure .)
5
Push button to cancel (release from) the
test run mode.
([TEST] disappears on the display and the status
returns to a normal.)
– 21 –
Wireless remote controller
1
When TEMPORARY button is pushed for
10 seconds or more, "Pi!" sound is heard
and the operation changes to test run. After
approx. 3 minutes, a cooling operation
starts forcedly.
does not start, check wiring again.
2
To stop a test operation, push TEMPORARY
button once again (Approx. 1 second).
Check wiring / piping of the indoor and outdoor
units in test run.
TEMPORARY
When a test run is not
performed properly
When a test run is not performed properly, refer
"T
current control function of the DC motor in this unit.)
cover the air discharge.
High-efficiency filter or opening the service panel.
indoor unit.
42-EN
11/13/18 2:18 PM 11/13/18 2:18 PM