Powering The Dvdpak2 - RIDGID SeeSnake DVDPak2 Operator's Manual

Table of Contents

Advertisement

Powering the DVDPak2

The DVDPak2 can be powered with a RIDGID 18 V Li-Ion
battery or by using the included AC/DC power converter�
To reduce the risk of electrical shock, use battery power
whenever possible� The power converter is not rated for
outdoor use� If using the power converter, only use the
DVDPak2 indoors�
Battery Power
The DVDPak2 can be powered with a RIDGID 18  V
Li-Ion battery� Rated at 2�2  Ah, a fully charged battery
should power the DVDPak2 from 2�5 hours to 3 hours
with normal usage� Actual battery operation time will
vary with battery rating and use�
With dry hands, slide a fully charged RIDGID 18 V Li-Ion
battery onto the battery dock located on the back of the
DVDPak2�
Figure 6 – Battery Installed
Ensure the battery locks onto the dock� See the Battery
Charger Operator's Manual for more information on
charging the battery.
When the DVDPak2 is ON and when the battery is in
the battery dock, the battery LEDs (See Item 1, Figure 7)
located underneath the hinge of the DVDPak2 monitor
will reflect the state of the battery as shown in Table 6.
Figure 7 – Battery Status LEDs
Battery
Status
Full
Medium
Low
Dead
Outlet Power
Power the DVDPak2 with the included AC/DC power
supply in accordance with the following:
1� Plug the power cord into the power supply�
2� Plug the power supply into the 40  W jack
located in the back of the DVDPak2�
3� Plug the power cord into a standard outlet�
If using an extension cord no longer than 25  ft [7�6  m]�
use a gauge of at least 18 AWG� If using an extension
cord longer than 25  ft [7�6  m], use a gauge of at least
16 AWG�
NOTE: To reduce the risk of electrical shock, only use the
external power supply indoors and always use dry hands
to connect the power supply.
1
2
Table 6
DVDPak2 Battery Status
External Power Not
External Power
Connected
Connected
Solid green
Green blinking
Green and red
Solid green and red
Solid red, 4 beeps
Red blinking
Solid red for
5 seconds, 5 second
beep and shutdown
blinking
15-19
English - 9

Advertisement

Table of Contents
loading

Table of Contents