Register Online; Three Year Limited Warranty - DeWalt DCV501H Instruction Manual

English
dust bowl release button
the dust bowl by pulling the dust bowl away from the
main housing.
2. Remove the filter assembly
dust bowl.
3. Twist counterclockwise and pull the filter cap
seperate it from the filter
install Filter
1. Attach the filter cap onto the filter and rotate it clockwise
to lock it firmly into position.
2. Push the filter assembly into the dust bowl.
3. Install the dust bowl onto the main housing and lock it
firmly into position.
Cleaning
iMPORTAnT: Maximum dust collection will only be
obtained with a clean filter and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
1. Once the filter is removed from the dust bowl, shake off
or lightly brush any dust from the filter.
2. Empty any dust from the dust bowl
and wash if necessary.
3. Rinse out the dust bowl with warm soapy water. Ensure
that the dust bowl is completely dry before using.
4. Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
5. It is very important that the filters are completely dry and
correctly in position before use.
6. Ensure the filters are completely dry for 24 hours
before refitting.
Replacement HEPA filter: DCV5011H
Do not use damaged filters. Replace any damaged filters
immediately.
Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product,
E
use of such accessories with this product could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your product are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact D
www.dewalt.com.
Repairs
The charger and batteries are not serviceable. There are no
serviceable parts inside the charger or battery pack.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a D
WALT authorized service center. Always use identical
D
E
replacement parts.
10
3 on the handle and remove
by pulling it out of the
4
21
20 .
2 into a trash bin
WALT
E
WALT call or visit our website:
E
WALT factory service center or a
E

Register Online

Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
to
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will allow
us to contact you in the unlikely event a safety notification
is required under the Federal Consumer Safety Act.
• Register online at www.dewalt.com.

Three Year Limited Warranty

WALT will repair or replace, without charge, any defects
D
E
due to faulty materials or workmanship for three years
from the date of purchase (two years for batteries). This
warranty does not cover part failure due to normal wear
or tool abuse. For further detail of warranty coverage and
warranty repair information, visit www.dewalt.com or call
1‑800‑4‑D WALT (1‑800‑433‑9258). This warranty does
E
not apply to accessories or damage caused where repairs
have been made or attempted by others. THIS LIMITED
WARRANTY IS GIVEN IN LIEU OF ALL OTHERS, INCLUDING
THE IMPLIED WARRANTY OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, AND EXCLUDES ALL
INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do
not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential
damages, so these limitations may not apply to you. This
warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, D
WALT will maintain the tool and replace worn parts
D
E
caused by normal use, for free, any time during the first
DC9071, DC9091, DC9096, DC9182, DC9280, DC9360,
DCB120, DCB122, DCB124, DCB127, DCB201, DCB203BT,
3 YEARs FREE sERViCE On D
DCB200, DCB203, DCB204, DCB204BT, DCB205, DCB205BT,
DCB206, DCB208, DCB230, DCB240, DCB606, DCB609,
nOTE: Battery warranty voided if the battery pack is
tampered with in any way. D
injury caused by tampering and may prosecute warranty
fraud to the fullest extent permitted by law.
90 DAY MOnEY BACK gUARAnTEE
If you are not completely satisfied with the performance of
your D WALT Power Tool or Nailer for any reason, you can
E
return it within 90 days from the date of purchase with a
receipt for a full refund – no questions asked.
WALT tools are covered by our:
E
1 YEAR FREE sERViCE
after purchase.
2 YEARs FREE sERViCE On
D WAlT BATTERY PACKs
E
DCB207, DCB361
WAlT BATTERY PACKs
E
DCB612, DCB615
WALT is not responsible for any
E