Rom (Read-Only Memory); Recalling Factory Default Values From Rom - DEC 2100 Operator's Manual

4.3.2 ROM (Read-Only Memory)

Read-only memory contains default values that are set at the factory. They
are called default values because they are stored in ROM and cannot be
changed. You can load these default values into operating memory while
in Menu Mode using the procedure shown in Table 4–3.
NOTE: Default values loaded from ROM are temporary values, and are
affected if the printer receives a reset command or is powered off. If you
want to retain the default values, you must save them in NVRAM (see
Section 4.3.3).
Table 4–3: Recalling Factory Default Values from ROM
Operation
1. Press to place the
On Line
printer off line.
— The On Line indicator
shuts off.
2. Press to place the
Menu
printer in Menu Mode.
3. Press once.
r
4. Press to
Enter
load the default
values from ROM.
5. Press to place
On Line
the printer on line.
— The On Line indicator
lights.
4–8 DEClaser 2100 Printer Operator's Guide
Display Reads
00 READY
FONT/FEED LAYOUT
LOAD<–ROM FONT/F
OK (momentarily)
#
LOAD<–ROM FONT/F
00 READY