Chapter 3: Headers & Jumpers Setup; How To Setup Jumpers; Detail Settings - Biostar 915GL-M7 Ultra Manual

CHAPTER 3: HEADERS & JUMPERS SETUP
3.1 H S
OW TO
The illustration shows how to set up jumpers. When the jumper cap is
placed on pins, the jumper is "close", if not, that means the jumper is
"open".
Pin opened
3.2 D S
ETAIL ETTINGS
JKBV1: Powe r Source Heade r for PS/2 Ke yboard and Mouse
Pin 1-2 close
Pin 2-3 close
Note:
In order to support this function "Power-on system via keyboard and
mouse", "JKBV1/JUSBV1/JUSBV3_1" jumper cap should be placed
on Pin 2-3.
JUSBV1/JUSBV3_1: Powe r Source Heade rs for USB ports
Pin 1-2 close
Pin 2-3 close
Note:
In order to support this function "Power-on system via keyboard and
mouse", "JKBV1" jumper cap should be placed on Pin 2-3.
915GL-M7 Ultra
J
ETUP UMPERS
Pin closed
Assignment
1
+5V +5V f or PS/2 key board and mouse
+5V Standby PS/2 mouse and keyboard are
1
Voltage powered with +5V standby v oltage.
Assignment
JUSBV1: +5V for USB ports at
1
+5V JRJ45USB1 & JUSB2.
JUSBV3_1: +5V for JUSB3/JUSB4.
JUSBV1: USB ports at JRJ45USB1
and JUSB2 are powered by +5V
+5V Standby
1
standby v oltage.
Voltage
JUSBV3_1: JUSB3/4 are powered by
+5V standby voltage.
12
Pin1-2 closed
Description
Description