One-Touch Tuning Stop Method - Mitsubishi Electric MR-J5 User Manual

One-touch tuning stop method

On MR Configurator2
Clicking the "Stop" button during tuning stops one-touch tuning. If one-touch tuning is stopped, "C000" will be displayed in the
error code status. After one-touch tuning is stopped, the servo parameters are restored to the values they had at the start of
one-touch tuning. Stop the servo motor before executing one-touch tuning again. In addition, perform one-touch tuning after
the moving part is returned to the tuning start position.
On a controller [G]
Writing "1EA5" in [One-touch tuning Stop (Obj. 2D52h)] during one-touch tuning stops the tuning. After one-touch tuning is
stopped, the servo parameters are restored to the values they had at the start of one-touch tuning. Moreover, stop the servo
motor before executing one-touch tuning again.
With push buttons [A]
Stop symbol
2 s interval
Error code
Pushing the "SET" button will switch to the initial screen.
Initial screen
3 ADJUSTMENT METHOD
34
3.2 One-touch tuning
Once the one-touch tuning mode is in progress, the one-touch tuning mode can be stopped
by pushing the "SET" button regardless of what is displayed on the screen.
The stop symbol and error code "C 000" (cancel during tuning) will be displayed by turns
with 2 s interval.
After the one-touch tuning is stopped, the servo parameters are restored to the values
at the start of the one-touch tuning.
When performing the one-touch tuning again, stop the servo motor once.