Whirlpool WFR7300S Instruction For Installation, Use And Handling page 50

Xtreme Flamma and Multi Flamma Burners (on some models)
To keep your burner in good conditions on the four crowns of your range, it is necessary to
perform cleaning regularly or every time there is a spill. Perform the following steps:
1. Make sure all components are at room temperature.
2. Remove the caps or crowns, burner and wash with soapy water and a sponge. Rinse
thoroughly and dry.
3. Verify that the gas outlet is not blocked, if so repeat step 5 of the section "Standard and
Super type burners"
4. When the burners are dry, place the burner back into position along with its caps or
crowns, making sure to align them as indicated in the figure.
5. Follow steps 5 to 7 for cleaning for "Standard and Super type burners".
Xpert standard and Xpert super burners. (On some models)
To keep your Xpert burner in good conditions, it is necessary to clean it periodically or whenever
there is a spill. Perform the following steps:
1. Make sure all components are at room temperature.
2. Remove the upper grates.
3. Remove the caps, the burner and wash with soapy water and a
sponge. Rinse thoroughly and dry.
4. Verify that the gas outlet is not blocked, if so repeat step 5 of the
section "Standard and super type burners".
5. When the components are dry, reposition the burner first, then the
intermediate cover and finally the upper cover, making sure to align
them as shown in the figure.
6. Follow steps 5 to 7 for cleaning for "Standard and super type
burners".
DO NOT INSTALL THE BURNER CAPS, WHILE THEY ARE
WET, DO IT ONLY UNTIL THEY ARE WELL DRY.
Control Knobs Cleaning method:
Wet cloth
1. Do not use abrasive or metal fiber cleaning products.
2. DO NOT SOAK NOR IMMERSE THE KNOBS IN
WATER
3. If there was a spill on the knobs for any reason, dry
them immediately with a dry, clean cloth.
Exterior of the Oven Door Cleaning method:
• Product to clean glass and paper towels or non-
abrasive plastic scouring pad
• Apply the glass cleaner with a soft cloth or sponge
but not directly on the panel.
• MIN FLAME
49
In some European factories the letter "W" of the part code mentioned herein will be automatically
30-Mar-2020 13:12:28 EDT | RELEASED
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")