Table of Contents
Advertisement
● If the suction flow is interrupted or the dust bag is full, the dust full indicator will
indicate this with a red light. Turn off the machine immediately and clean the inlet
filter. Empty the dust bag. Turn the unit on again.
● Note: Pay attention to unusual noises when using the device. This could indicate a
malfunction or blockage in either the flexible hose or telescopic pipe.
GENERAL CLEANING AND MAINTENANCE
HOW TO EMPTY THE DUST CONTAINER
IMPORTANT: The dust bag must always be in place when operating the hand vacuum
● After removing the flexible hose, press the cover lock button and open the dust
container.
● Remove the dust filter form the container.
● Replace the dust filter in the container.
● Close the dust container until it is locked in the position.
PLEASE NOTE: The dust bag can only be washed with water and must be left for 24hrs to
dry before next use.
CLEANING THE FILTERS
How to clean the motor filter:
● Open the dust bag container compartment remove the dust bag.
● Remove the motor filter located behind the dust bag.
● Place the cleaned filter back into the original position.
PLEASE NOTE: The motor filter can be washed with water only. Do not use any detergents
when washing the motor filter. The motor filter must be left for 24hrs to dry before next use.
How to clean the exhaust filter:
Advertisement
Table of Contents
