Fault Finding - Hoover PET PRO HBC2000P Instructions And Warranty

● Detach the grill located at the rear of the vacuum cleaner by pulling it firmly away
from the appliance.
● Remove the outlet filter.
● Clean the filter by gently tapping it.
● Place the filter back into the rear of the vacuum cleaner.
● Return the grill to its original position.
IMPORTANT: All the filters and the dust bag need to be cleaned after each use. If the
product stops working during usage, it might have overheated due to dirty filters.
Please check and clean all the filters. Wait one hour before switching the product on
again.

FAULT FINDING

Problem
Motor does not start
Suction power is weaker
Power cord not rewinding
completely
Possible Reason
● Power cord not firmly
plugged into outlet
● Outlet damaged
● The vacuum cleaner is
not switch on at the
outlet
● Motor has overheated
● Blockage in Vacuum
inlet of pipes
● Dust filter needs
cleaning
● Dust container not in
position
● Filter blocked
The power cord may have
been pulled off from the
internal guide wheel
Action
● Plug unit firmly
● Check the outlet
● Switch on the
appliance
● Clean all the filters and
empty the dust bag
● Remove the blockage
● Clean the dust filter
● Close the dust
container
● Clean the filters and
empty the dust bag
Gently pull the cord away
from the vacuum cleaner
and press the rewind pedal
again.