Servicing Mode; Auto Switch Operation; Indicator Panel - Panasonic CS-E9EKK Service Manual

11 Servicing Mode

11.1. Auto Switch Operation

The below operations will be performed by pressing the "AUTO" switch.
1. AUTO OPERATION MODE
The Auto operation will be activated immediately once the Auto Switch is pressed.
2. TEST RUN OPERATION (FOR PUMP DOWN/SERVICING PURPOSE)
The Test Run operation will be activated if the Auto Switch is pressed continuously for more than 5 sec. A "beep" sound will
occur at the fifth sec., in order to identify the starting of Test Run operation.
3. REMOTE CONTROLLER RECEIVING SOUND ON/OFF
The ON/OFF of remote controller receiving sound can be change over by pressing the following step:
a. Release the Auto Switch after Test Run operation is activated.
b. Then, within 20 sec., after a., press Auto Switch for more than 5 sec.
A "beep" "beep" sound will occur at the fifth sec., then release the Auto Switch.
c. Within 20 sec. after b., press Auto Switch again. Everytime Auto Switch is pressed (within 20 sec. interval), remote
controller receiving sound status will be reversed between ON and OFF.
Long "beep" sound indicates that remote controller receiving sound is OFF.
Short "beep" sound indicates that remote controller receiving sound is ON.

11.2. Indicator Panel

LED
Color
Light ON
Light OFF
Note:
• If POWER LED is blinking, the possible operations of the unit are Hot Start, during Deice operation, operation mode judgment,
or ON timer sampling.
• If Timer LED is blinking, there is an abnormality operation occurs.
POWER TIMER
Green Orange
Operation ON Timer Setting ON
Operation OFF Timer Setting OFF
QUIET
Orange
Quiet Mode ON
Quiet Mode OFF
30
POWERFUL
Orange
Powerful Mode ON
Powerful Mode OFF