Servicing Mode; Auto Off/On Button - Panasonic CS-E7GKEW Service Manual

14. Servicing Mode

14.1 Auto OFF/ON Button

Auto OFF/ON
Button Pressed
Auto Operation
1. AUTO OPERATION MODE
The Auto Operation will be activated immediately once the Auto OFF/ON button is pressed. This operation
can be used to operate air conditioner with limited function if remote control is misplaced or malfunction.
2. TEST RUN OPERATION (FOR PUMP DOWN/SERVICING PURPOSE)
The Test Run Operation will be activated if the Auto OFF/ON button is pressed continuously for more than 5
seconds. A "beep" sound will be heard at the fifth seconds, in order to identify the starting of this operation
(Forced Cooling Operation). Within 5 minutes after Forced Cooling Operation starts, the Auto OFF/ON
button is pressed for more than 5 seconds, 2 "beep" sounds will occurs at 5
starting of Forced Heating Operation.
The Auto OFF/ON button may be used together with remote control to set/ change the advance setting of air
conditioner operation.
Auto OFF/ON
Button Pressed
Auto Operation
3. REMOTE CONTROL NUMBER SWITCH MODE
The remote Control Number Switch Mode will be activated if the Auto OFF/ON button is pressed
continuously for more than 11 seconds (3 "beep" sounds will occur at 11
Control Number Switch Mode is in standby condition) and press any button at remote control to transmit and
store the desired transmission code to the EEPROM.
For transmission code selection explanation, please refer to "Select Remote Control Transmission Code"
4. REMOTE CONTROL RECEIVING SOUND OFF/ON MODE
The Remote Control Receiving Sound OFF/ON Mode will be activated if the Auto OFF/ON button is pressed
continuously for more than 16 seconds (4 "beep" sounds will occur at 16
Control Receiving Sound OFF/ON Mode is in standby condition) and press "AC Reset" button and then
press "Check" button at remote control.
Press "Auto OFF/ON button" to toggle remote control receiving sound.
- Short "beep": Turn OFF remote control receiving sound
- Long "beep": Turn ON remote control receiving sound
After Auto OFF/ON button is pressed, the 20 seconds counter for Remote Control Receiving Sound OFF/ON
Mode is restarted.
5 sec
Test Run Operation
(Forced Cooling Operation)
Beep
Main unit always continue Test Run (forced cooling) operation
5 sec 8 sec
Test Run Operation
(Forced Cooling Operation) (Forced Heating Operation)
Beep Beep x 2
Auto OFF/ON
Button Pressed
5 sec
Stop Test Run Operation
(Forced Heating Operation)
Beep x 2
11 sec
Test Run Operation Remote Control
Number Switch Mode
Beep x 3
Press any key at
remote control
52
Auto OFF/ON
Button Pressed
Stop
th
seconds, in order to identify the
16 sec
Remote Control Receving
Sound OFF/ON
Beep x 4
Press "AC Reset" & "Check"
key at remote control
th
seconds to identify the Remote
th
seconds to identify the Remote