Download Print this page

Zanussi ZDF1001 User Manual page 45

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 39
Using the detergent
1
A
3
Put the detergent or
the tablet in compart-
ment (A).
B
If the programme has
a prewash phase, put
a small quantity of
detergent in com-
partment (B).
Combi detergent tablets
These tablets contain detergent, rinse aid and
other added agents. Be sure that these tablets
are applicable to the water hardness in your
area. Refer to the instructions on the packag-
ing of the products.
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and the
rinse aid dispenser. The rinse aid indicator al-
ways comes on if the rinse aid dispenser is
empty.
www.zanussi.com
2
A
4
1. Adjust the water softener to the lowest lev-
el.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the ap-
pliance.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rins-
ing phase, without detergent and without
dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode
to:
• Start a programme.
• Set the level of the water softener.
Turn the programme knob until the programme
marker is aligned with a programme on the
control panel:
• If the programme duration flashes in the dis-
play, the appliance is in setting mode.
• If the programme duration in the display is
not flashing, the appliance is not in setting
mode.
To put the appliance in setting mode, press
and hold Cancel until the programme duration
flashes in the display and the phase indicators
for the programme come on.
Starting a programme without delay start
1. Open the water tap.
2. Close the appliance door.
3. Turn the programme knob until the pro-
gramme marker is aligned with the pro-
45

Advertisement

loading