Water connection • This appliance is intended to be used in • Make sure not to cause damage to the water household and similar applications such as: hoses. – Staff kitchen areas in shops, offices and other working environments www.zanussi.com...
• Do not put flammable products or items that are wet with flammable products in, near or on the appliance. Product description Worktop Lower spray arm Filters Rating plate Rinse aid dispenser Detergent dispenser Salt container Water hardness dial Upper spray arm Upper basket www.zanussi.com...
Crockery, cutlery, pots and Wash 70 °C pans Rinses Normal soil Prewash Half-load Crockery and cutlery Wash 65 °C Rinses Fresh soil Wash 65 °C Crockery and cutlery Rinse Normal soil Prewash Half-load Crockery and cutlery Wash 50 °C Rinses www.zanussi.com...
Start a programme to remove them. Contact your local water authority to know Do not use detergent and do not load the the water hardness in your area. baskets. 2. Fill the salt container. 3. Fill the rinse aid dispenser. www.zanussi.com...
Page 6
Example: 5 flashes + tion 1 or 2. pause + 5 flashes = level 5. 4. To adjust the level of the water softener, press the start button. Each time you press the start button you go to the next level. www.zanussi.com...
Put 1 litre of water in the salt container (on- ly for the first time). To adjust the released quantity of rinse aid, turn the selector between position 1 (lowest quantity) and position 4 (highest quantity). Daily use 1. Open the water tap. www.zanussi.com...
Page 8
Do not use more than the correct quantity other added agents. Be sure that these tablets of detergent. Refer to the instructions on are applicable to the water hardness in your the detergent packaging. area. Refer to the instructions on the packaging of the products. www.zanussi.com...
Page 9
To put the appliance in setting mode, press and hold the start button until the start indicator goes off . www.zanussi.com...
The appliance does not start or it stops during With some problems, different indicators operation. flash continuously or intermittently at the Before you contact the Service, refer to the in- same time to show an alarm code. formation that follows for a solution to the prob- lem. www.zanussi.com...
Page 11
If other alarm codes show, contact the Service. when the problem occurred. The programme continues from the point of interruption. The washing results and drying results are not satisfactory Problem Possible cause Possible solution The dishes are not clean. The filters are clogged. Clean the filters. www.zanussi.com...
Page 12
The dishes are wet and The rinse aid dispenser is empty. Make sure that there is rinse aid in the matt. rinse aid dispenser. The quality of the rinse aid can be the Try a different brand of rinse aid. cause. www.zanussi.com...
By ensuring this product where you purchased the product. is disposed of correctly, you will help prevent potential negative consequences for the • Discard correctly the packaging material. Re- cycle the materials with the symbol www.zanussi.com...