Kenmore 111.7503 Series Use & Care Manual page 14

REMOVING AND REPLACING
REFRIGERATOR DOORS
WARNING
Risk of electric shock!
Before removing top hinge cover
• Shut off the water supply to the appliance.
• U nplug the appliance or switch off power from the
breaker or fuse panel.
To remove the left refrigerator door:
1. Remove top hinge cover using a phillips screwdriver by
removing 5 screws.
2. Remove the hinge grounding wire screw and pull the
two grounding wire connections away from the hinge.
Disconnect the three wire harnesses and the water
tube. Push in the small first ring on the connection
collar to remove the tube.
3. Using a large phillips screwdriver, turn top hinge
fastener counterclockwise to remove the top hinge
plate.
CAUTION: After the hinge is removed, the door can
fall down forward. Hold the door to prevent it from
falling.
REFRIGERATOR INSTALLATION
Push In
4. Lift the door from the middle hinge pin and remove
the door. Place the door, inside facing up, on a non-
scratch surface.
If the refrigerator doors are not
the appliance.
properly aligned:
WARNING
down.
Risk of electric shock!
Before removing the top panel:
1. Shut off the water supply to the
appliance.
To remove the right refrigerator door:
1. Remove top hinge cover using a phillips screwdriver by
removing 5 screws.
2. Using a large phillips screwdriver, turn top hinge
fastener counterclockwise to remove the top hinge
plate.
CAUTION: After the hinge is removed, the door can
fall down forward. Hold the door to prevent it from
falling.
appliance.
2. Mount the base plate.
tighten.
5. Move the hinge sideways to adjust
the refrigerator door.
3. Lift the door from the middle hinge pin and remove
the door. Place the door, inside facing up, on a non-
scratch surface.
14