Adapter Installation/Removal - NEC N8105-53 User Manual

E-4

2.2. Adapter installation/removal

2.2.1. Before Installation
If you have already used another graphics accelerator
If you are using a graphics accelerator other than this product, please uninstall the existing graphics accelerator
display driver before installing the driver for this product.
Changing BIOS settings
Before installing this board, you need to change the BIOS settings of the server.
Boot the server and press F2 during boot to start BIOS Setup and change the following settings.
BIOS Menu → Advanced → PCI Subsystem
■Installation
[Onboard VGA Controller] Disabled
[VGA Priority]
■Remove
[Onboard VGA Controller] Enabled
[VGA Priority]
After changing, save the settings with [Save Changes and Exit] and turn off the system power.
In the case of built-in shipment (Build To Order; BTO)
Even if you purchase this product by built-in shipment, please be aware that it will be necessary to install the
display driver.
If you hear a beep when powering on, this product is not recognized correctly. In that case,
NOTE:
make sure that the card is completely inserted into the PCI-Express slot.
Offboard
Onboard