Dyson pure hot+cool HP01 Operating Manual page 11

Sleep timer
To set the sleep timer, press and hold the timer button
to select the desired time. When time reaches zero, the
appliance will go into standby mode. To cancel, reduce
the time until two dashes appear.
When using the sleep timer, the LED display will turn off
after 5 seconds of inactivity.
Diffused and personal heating modes
07.07.2015 15:36 - C76365_HP01_OPMAN_CN_X264A-OPMAN UP ISSUE 06_07_15 76365.indd_15_4c0s
Diffused mode
Press the wide angle button
to change from personal
heating to whole room
heating.
Heating and cool modes
work in this mode.
Personal heating mode
Press the narrow angle
button to change from whole
room heating to personal
heating.
Heating and cool modes
work in this mode.
Tilt function
Carefully hold the base and the main body. Tilt the amplifier
forward or backward for the required airflow angle.
Oscillation and airflow speed control
Oscillation control
To start the appliance
oscillating, press the
oscillation control button.
To stop the appliance
oscillating, press it again.
The appliance will not
oscillate when the control
buttons are pressed.
Airflow speed control
To change the airflow speed
press the airflow control
button. The digital display
will show the new fan speed.
If in heater mode after
2.5 seconds it will change
back to displaying the target
temperature.
11