Table of Contents
Advertisement
CITY SERIES 60
maintenance
12. Loosen 8 screws in locations shown below (4 at front and 4 at rear)—
slide burner to the left away from the orifice and lift out.
tooltip
tooltip
13. Remove burner orifice with a 3/8" wrench. Use another wrench to hold
on to the elbow behind the orifice. Discard orifice. Reinstall new burner
orifice LPG stamped #50 and tighten.
tooltip
14. Remove pilot retainer clip with pliers and pull off the pilot cap to expose
the pilot orifice.
Pilot retainer clip
920-179
88
| City Series CB60E-1
CB60E shown
Burner screw locations
CB60E shown
Slide burner to the left and lift out
CB60E shown
Burner Orifice
Location
2
15. Unscrew the pilot orifice with the Allen key; then replace with the LPG
pilot orifice and the pilot cap, provided in the kit.
16. Reinstall pilot cap and pilot retainer clip.
17. Prior to installing burner—adjust aerations settings - to 3/8" for LP. Re-
install burner (see Step 11).
18. Make sure aeration cap tab is inserted into the slot on the bracket. Adjust
aeration handle if necessary.
Aeration cap tab
19. Reverse steps 1 to 11.
20. Ensure the pilot lilght is in the correct orientation to the burner. Recon-
nect the gas and electrical supplies. Start the appliance (see section
on Lighting Instructions). Ensure that pilot and burner ignition are com-
pleted without delay. Check inlet and outlet pressures at full load. With
a soapy solution, leak test the entire system. Verify correct flame and
pilot appearance.
21. See Gas Pipe Pressure Testing in manual.
City Series
LP SYSTEM DATA
Min. Supply Pressure
Manifold Pressure - High
Manifold Pressure - Low
Orifice Size
Maximum Input
Minimum Input
Altitude
Installer Notice:
These instructions must be left
with the appliance
Slot on bracket
aeration
handle
11" WC (2.73kpa)
10.5" WC (2.62 kpa)
2.9" WC (0.72 kpa)
#50 DMS
36,000 Btu/h (10.54 kW)
19,500 Btu/h (5.71 kW)
0-4500 ft (0-1372m)
.
10.31.19
Advertisement
Table of Contents
